How to install Probrico Hinges: CHW093HA?

How to install CHW093HA?

CHW093HA is 165 degree hinges soft close for face frameless cabinet.

1,Check the hinge you receive.

Each Hinge includes: Hinge Body+Mounting Plate+4 screws (Press the hinge top, can remove the plate easily.)

2,Drill Hole.

CHW093HA is full overlay.( means the door panel will cover the full cabinet side panel.)

(The following picture shows hinge when closed)

Confirm the Hole location.

H: Mounting Plate height value. For CHW093HA, H=0

D: The cabinet panel thickness. For CHW093HA, available door thickness is 14-26mm.

K: The Distance of the door frame to the side of the drilled Hole. K=D-14

For example, if your cabinet panel is 18mm, K=4,

So the distance of hole center to side frame is 35/2+4=21.5mm.

The distance of hole center to top frame(LF) is according to your door size, normally LF is 100mm-125mm

Mark the location of the center of the circle, and then use a 35mm forstner drill bit, hole depth of 11.5mm.(12mm-13mm are ok)


3,Install the Hinge Body.

Put hinge cup to the hole, then tighten the screws. (The two screws distance is 45mm) ( Mark a line before tighten the screws)

4,Install the Mounting Plate.

Fasten the hinge plates to cabinet side panel using the screws provided and a power drill. The Distance of the screw hole to the frame is 37mm.

LF is the same as the hinge body. So mark sure the Hinge Body and mounting Plate are at the same level.


5, Finish the Installation.

Hold the door, slide the hinge body into the mounting plate. and snap together

6, Minute adjustment

After installation, if the door is not closed well, you could adjust by these screws.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.